Bonder poliestere leggero B10


Applicable directly on freshly laminated surfaces free from dust, fibres, dirt and condensation. Completely hardened surfaces must be sanded and cleaned thoroughly. Check the suitability for use on surfaces obtained from paraffin resins. Mix the product directly in its package and mix it with 1.0 – 2.0% of liquid catalyst (methyl ethyl ketone peroxide), bearing in mind that the quantity of catalyst selected depends both on the temperature of use and on the processing times required. The recommended temperature range for use is between 16 and 28° C. The product contains color changer to verify the homogeneous dispersion of the peroxide. It is applied manually, with a spatula or by machine. For quantities greater than 5 kg, mixing with a whisk is recommended, while for 200 l drums the aid of a follower plate extruder-mixer guarantees the best mixing efficiency. The product has also been formulated to be sprayed, where the large surfaces of yachts or the rapid cycles of mass production require it. For further details and for the recommended application procedures, refer directly to the “Guidelines for Adhesive Mastics”, available at the INTEC Technical Assistance Centre. In its original packaging, the product can be used for 6 months if stored indoors away from direct sunlight, at temperatures not exceeding 20°C. There may be a change in frost weather.


Light adhesive mastic based on unsaturated polyester resins, microspheres and light reinforcing fibres
Specifically formulated for the composite sector for gluing slabs and inserts in expanded Balsa, PVC, PET, PIR and polyurethane, it is easy to spread and de-aerate thanks to its excellent thixotropy. Under pressure or under vacuum, it flows easily, saturating every crack and cavity in the foam, thus guaranteeing high mechanical, thermal and chemical properties of the sandwich laminate. In addition to the low specific weight of its formulation, there is limited shrinkage during the hardening phase and excellent adhesion performance even on high density foams.


Recommended: polyester fiberglass and vinylester laminates; raw sheet metal, degreased and sanded.


In.Te.c (Slem)